Auto Bias Modules Manual
- AB-Qi-M125 module shown Remote LED modification
- Module AB-4 for 4 tubes, PP & PPP amps, requires 6.3VAC & bias supply from the amps circuit, with TTL error signal output.
- Module AB-2 for 2 tubes, PP & Single Ended amps, requires 6.3VAC & bias supply from the amps circuit, with TTL error signal ouptut.
- Module ABS-Qi+ for 4 tubes, PP & PPP amps, with a built in 6.3VAC AND bias supply, 115V or 240VAC powered transformer, fully autonomous
- Module AB-D-MKIII. This module has been designed to fit the Dynaco MKIII amp chassis!
- Module AB-Di-MKIV. This module has been designed to fit the Dynaco MKIV amp chassis!
- Module AB-Qi-M125 This module has been designed to fit the Bob Latino M125 mono block power amp
- Module AB-Qi-ST70/ST120 This module has been designed to fit the Dynaco ST-70 chassis for the new generation Bob Latino ST-70 and ST120 stereo amps
- Module AB-Oi for 8 tubes, PP & PPP amps, with a 1:1 isolation transformer for use in amps
- Module AB-Qi for 4 tubes, PP & PPP amps, with a 1:1 isolation transformer for use in amps
- Module AB-Q for 4 tubes, PP & PPP amps, requires 6.3VAC & bias supply from the amps circuit